|

|
|
Home | Products &
Services | Preventative Plans
| What's New | Helpful
Hints | About Us | Testimonials
| Contact Us |
 |
| Glossery |
|
|
- AFUE
- Stands for Annual Fuel Utilization Efficiency. This
number represents how efficiently a furnace converts
fuel to energy. The higher the rating, the more
fuel-efficient the furnace is.Percentage of fuel used
for heating.
- Air Handler
- The portion of your air conditioner or heating system
that forces air through your home's ductwork.
- BTU
- Stands for British Thermal Units. This number
indicates the amount of heat it takes to raise one pound
of water one degree Fahrenheit. The higher the BTU
rating, the larger the heating capacity of the furnace
or air conditioner. Homes are measured to determine the
number of BTUs required from a heating or cooling
system.
- Capacity
- Heating and cooling equipment capacities are measured
in BTUs. How much heat can the air conditioning unit
remove.
- Carbon Monoxide
- A colorless, odorless, highly poisonous gas produced
when carbon burns without sufficient air nearby.
- CFM
- Stands for Cubic Feet per Minute. A measurement of
airflow that indicates how many cubic feet of air pass
by a stationary point in one minute. The higher the
number, the more air is being forced through the system.
- Compressor
- The Compressor is the most important piece of a
heating or cooling system. Located in the outdoor unit,
the compressor is responsible for pumping refrigerant
throughout the system.
- Condenser Coil
- The outdoor portion of a heating or cooling system
that either releases or collects heat from the outside
air, depending on the time of year. The Condenser Coil
is connected directly to the home's Air Handler and is
also known as the Outdoor Coil.
- Damper
- A movable plate that controls airflow through a
ductwork system. Dampers are used to direct air to the
areas of the home that need it most.
- Ductwork
- Hollow pipes used to transfer air from the Air Handler
to the air vents throughout your home. Ductwork is one
of the most important components of a home heating and
cooling system.
- Evaporator Coil
- This is where refrigerant evaporates as it removes
heat from the air that is passed over it. The Evaporator
Coil is located in the indoor unit and is also referred
to as the Indoor Coil.
- FAQ
- Stands for Frequently Asked Question. Also refers to a
list of Frequently Asked Questions.
- Heat Exchanger
- The part of a furnace that transfers heat to nearby
air. That air is then distributed through the Ductwork
throughout your home.
- Heat Pump
- A heating and air conditioning unit that heats or
cools by moving heat.
- HSPF
- Stands for Heating Seasonal Performance Factor.
Indicates how efficiently a Heat Pump is working. A
higher number means the unit works more efficiently.
Most new units have ratings from 7.0 to 9.4.
- Humidifier
- A component that adds moisture to the air before it is
distributed by the Ductwork throughout the house.
- HVAC
- Stands for Heating, Ventilation, and Air Conditioning.
- Indoor Coil
- See: Evaporator Coil
- Outdoor Coil
- See: Condenser Coil
- Refrigerant
- A chemical that cools air as it evaporates. Air
conditioning systems use Refrigerant in the Evaporator
Coil to cool air as it passes by.
- Refrigerant Lines
- Two copper lines that connect the Condenser (Outdoor)
Coil to the Evaporator (Indoor) Coil.
- SEER
- Stands for Seasonal Energy Efficiency Ratio. An
efficiency measurement that is similar to Miles Per
Gallon for cars. The higher this number, the more energy
efficient they system is. New units have SEER ratings
from 10 to 17 BTUs per watt.
- Single Package
- One outdoor unit that contains both a heating and a
cooling system.
- Split System
- A combination heat pump or air conditioner with indoor
components such as a furnace or blower coil. To maximize
effectiveness, Split Systems should be matched.
- Thermostat
- A device that allows you to control the temperature
inside your home by telling the heating or cooling
system how much air to produce.
- Zoning
- The dividing of a home into different areas each with
their own heating and cooling properties. For example,
you might prefer to have the kitchen area of your home
be slightly cool, while at the same time keeping the
temperature in the bedrooms warmer.
|
|
|
Home | Products &
Services | Preventative Plans
| What's New | Helpful
Hints | About Us | Testimonials
| Contact Us |
|
Sales: 520.887.2926
© Copyright, 2001 - 2008. All
rights reserved.
|
|